The active belt bridge is used as transfer unit for bridging the conveyor trench between the basic unit and the return unit between section start or end and a third-party conveyor or in connection drive
- Only for flat conveyor chain and static friction chain
- The active belt bridge is driven by a transmission (on the drive or return unit side)
- Suitable for conveyed materials from approx. 80 mm in length (depending on the speed, position of the center of gravity, product friction, etc.)
- Installation possible on both the drive and return side (make sure to use the correct L/R version)
- Not permitted for wet operation, rough ambient conditions or sharp-edged products
- Accumulation not permitted
- Load depending on the speed (see diagram)
- The speed of the adjacent conveyor should be approximately the same to prevent premature wear
- Simple transmission of the drive force using hexagonal hollow shafts integrated into the base unit or return unit as standard
- Can be retrofitted into a standard configuration at any time
- Easy replacement of the belt from the top
Technical data
| Property | Value |
|---|
| Condition on delivery | Some assembly required |
| Weight [kg] | 2 |
| Size [b] [mm] | 120 |
| Scope of delivery | Incl. fastening material, transmission and protective cover |
| Material | Aluminum/non-rusting steel 1.4301/PA/PE/ABS/PUR |
Item data
| Property | Value |
|---|
| Manufacturer | Bosch Rexroth |
| Part number | 3 842 558 005 |
| Designation | CONNECTING KIT VF+ 120 BRIDGE BELT R |
| Product area | Conveyor and transfer systems › VarioFlow plus chain conveyor system › VarioFlow plus aluminum system › Drive and return components AL › Drive and return unit AL, bridges and connection shafts AL |
Manufacturer data sheet and CAD data available on request.
