CONNECTING KIT VF+ 65 BRIDGE BELT L

Connection kit active belt bridge VFplus 65 L

• The active belt bridge is used as a transfer unit for bridging the conveyor trench
  - between the basic unit and return unit
  - between the start or end of a conveyor section and a third-party conveyor
  - in the connection drive
• Only for flat conveyor chain and static friction chain
• The active belt bridge is driven by a transmission (on the drive or return unit side)
• Suitable for conveyor belts from approx. 80 mm in length (depending on the speed, position of the center of gravity, product friction, etc.)
• Installation possible on both the drive and return side (make sure to use the correct L/R version)
• Not permitted for wet operation, rough ambient conditions or sharp-edged products
• Load depending on the speed
• The speed of the adjacent conveyor should be approximately the same to prevent premature wear
• Simple transmission of the drive force using hexagonal hollow shafts integrated into the base unit or return unit as standard
• Can be retrofitted into a standard configuration at any time
• Easy replacement of the belt from the top
• Accumulation not permitted

Technical data

Item data

Manufacturer data sheet and CAD data available on request.