Slide stop, can be lowered pneumatically, dampened stop
- Stopping on the outside of the frame module
- Can be used in reversible operation
- Design permits installation with a section gap from a = 90 mm when space is limited
- Suitable for mounting on an ST 2/… section with a profile width of 45 mm or an ST 2/…-H section with a profile width of 50 mm
- 4 positions can be moved to pneumatically: upper, lower position and stop rail in the extended and retracted state
- 3 positions can be detected: top, bottom and retracted stop rail
- Additional possibilities for installing sensors, advantageous in restricted conditions
- Can be combined with WT 2 and WT 2/F
- Notice: Combination with WT 2/LS not possible
- The slide stop is used in a transverse section that connects more than two longitudinal sections and that requires supplementary stops
- A lift transverse unit can feed in the workpiece pallet onto the longitudinal section when the slide stop is activated
- When depressurized, the pneumatically adjustable slide stop is extended to the upper end position
- Mounted inside the tracks, directly on the conveyor section
Technical data
| Property | Value |
|---|
| Condition on delivery | Assembled |
| ESD | Yes |
| required compressed air connection [pmax] [bar] | 6 |
| required compressed air connection [pmin] [bar] | 4 |
| Operating temperature [T] max | 60 °C |
| Workpiece pallet total weight [mG] [kg] | 130 |
| Pneumatic straight connection [Ø] [mm] | 6 |
| Scope of delivery | Incl. fastening material for installation on conveyor section
Position sensing
Right-angle connector for the push in air connections |
| Material information | Housing: aluminum; hard anodized
Latch: steel |
| Min. workpiece pallet weight m | 15 kg |
| Pneumatic circuit diagram | 1 Not included in the scope of delivery |
| Maximum permissible mass workpiece pallet mG at nominal speed vN 6 m/min | 130 kg |
| Maximum permissible mass workpiece pallet mG at nominal speed vN 9 m/min | 110 kg |
| Maximum permissible mass workpiece pallet mG at nominal speed vN 12 m/min | 110 kg |
| Maximum permissible mass workpiece pallet mG at nominal speed vN 15 m/min | 100 kg |
| Maximum permissible mass workpiece pallet mG at nominal speed vN 18 m/min | 100 kg |
| Recommended accessories | Clamping holder
Sensor M12x1 with rated switching distance SN = 4 mm, overall length 45 mm |
| Weight [kg] | 4.2 |
Item data
| Property | Value |
|---|
| Manufacturer | Bosch Rexroth |
| Part number | 3 842 564 563 |
| Designation | SLIDE STOP VA 2/D-130 |
| Product area | Conveyor and transfer systems › Transfer system TS 2plus › Transportation control TS 2plus › Slide stops |
Manufacturer data sheet and CAD data available on request.
